From deli and meat cases to wall vegetable coolers, walk-ins, and rooftop units — SWIFT Hvacr handles the full install: survey, sizing, rigging, piping, startup, and commissioning. One crew, one accountable partner, across every location you run.
A repeatable process is what makes an install predictable across one store or fifty.
We walk the store or facility, measure the opening, review electrical and drain locations, check existing rack or condensing capacity, and confirm what the equipment actually needs before anything is ordered.
Heat load and line-set calculations, refrigerant selection, airflow and duct design for HVAC, and case-to-rack circuiting for refrigeration — so the system holds temperature at peak load, not just on paper.
Coordinated equipment delivery, rigging, and placement — including crane sets for rooftop units and careful in-store set for display cases, scheduled around your business hours.
Brazing under nitrogen, evacuation to spec, drain and condensate lines, insulation, electrical hookup with a licensed partner, and controls wiring — all to code and documented.
Leak check, weighed-in refrigerant charge, superheat and subcooling verification, defrost and controls programming, temperature logging, and a full pull-down test before handoff.
We train your staff on controls and daily checks, hand over commissioning reports and warranty registration, and roll the new equipment into a preventative maintenance schedule.
Service deli cases, self-contained and remote meat cases, seafood and cheese merchandisers. We handle case joining, end panels, rack circuiting, drain runs, and temperature verification so product holds safe temps from day one.
Open-front multi-deck produce coolers and wall cases installed to hold tight, even temperature across the whole run — with correct air-curtain performance, night curtains, and misting or humidity control where specified.
Rooftop units, split systems, make-up air, and exhaust — sized, rigged, curbed, and commissioned. We handle change-outs on live stores with minimal downtime and full controls integration.
Every SWIFT Hvacr technician works to code, carries the proper credentials, and documents the work — so your compliance file is always clean.
State-licensed commercial mechanical contractor
Fully bonded for commercial and multi-site work
General liability & workers' comp coverage
Aftermarket technician network standards
Certified refrigerant handling & compliance
Send us the equipment list and store plans — we'll walk the site and put a scope and schedule together.